The following double tube clamp manufacturers will bring everyone to understand the relevant knowledge of the lower tube clamp:
1, pipe clamp application range
The light series pipe clamps are applied to common mechanical pressure pipes of 6 size series, and the outer diameter of the pipe is 6-57mm.
The double series pipe clamp is applied to the mechanical pressure pipes of 5 series series, and the outer diameter of the pipe is 6-42mm.
Heavy duty pipe clamps are used in 8 series of high mechanical pressure pipes with an outer diameter of 8-273mm.
2, pipe clamp material characteristics
Density, flexural strength, impact toughness, compressive strength, modulus of elasticity, tensile strength, temperature resistance, color
3, pipe clamp installation procedures
Before assembling on the welding plate, in order to better determine the direction of the clamp, it is recommended to mark the fixed position first, then weld it, insert the lower part of the pipe body, and place the pipe to be fixed. Then put the other half of the tube body and cover and tighten with screws. Do not directly solder the bottom plate of the pipe clamp.
On the grounding rail, the rail can be welded to the foundation or fixed with screws. Then push the rail nut into the rail and turn it 90 degrees. Insert the lower half of the tube into the nut, put the tube to be fixed, and then put it. The upper half of the tube body and cover are fixed with screws.
Stack the assembly, the guide rail can be welded on the foundation, or fixed with screws. First install the upper and lower half of the pipe body, put the pipe to be fixed and put the upper half of the pipe body, fix it with screws, and pass the anti-loose cover. Prevent it from turning. Then install the second pipe clamp in the same way as above.
When assembling the elbow, when assembling the elbow, it should be fixed directly at the front and rear of the elbow with the Yongsheng pipe clamp. It is recommended that such a support point be a fixed position.