Before the device is welded on the board, it is very good to determine the direction of the clip. It is recommended to first make the symbol at the fixed position, then weld it on the weld, insert the lower part of the tube body, and put the tube to be fixed. Then put the other half of the tube body and cover and tighten with screws. Do not directly solder the bottom plate of the pipe clamp.
On the grounding rail, the rail can be welded to the foundation or fixed with screws. Then push the rail nut into the rail and turn it 90 degrees. Insert the lower half of the tube into the nut, put the tube to be fixed, and then put it. The upper half of the tube body and cover are fixed with screws.
Stacking device, the guide rail can be welded on the foundation, or fixed by screws, firstly install the upper and lower half of the pipe body, put the pipe to be fixed and then put the upper half of the pipe body, fix it with screws, and pass the anti-loose cover Avoid it changing. Then install the second pipe clamp, the same way as above.
The device for bending the pipe, when the device is bent, should be fixed directly at the front and rear of the elbow with a Sturdy pipe clamp. It is claimed that such a support point should be in a fixed orientation.