新闻中心

News

Product

Contact

Jiangsu Oubang Pipe Clamp Manufacturing Co., Ltd.

Contact:  Porco

222.png 333.jpg 5555.png

Email : obpipeclamp@qq.com

Skype/WhatsApp/Wechat/mob

+86 183 6168 0199

Tel/Fax : 86 515 87226455

Address : No. 13, Yaoqiao 1st Road, SME Park, Funing County, Yancheng City


What are the specifications for industrial pipe clamps?

Your current location: Home >> News >> Technical Knowledge

What are the specifications for industrial pipe clamps?

Date:2018-05-23 Author:Jiangsu Oubang Pipe Clamp Manufacturing Co., Ltd. Click:

On the grounding rail, the rail can be welded to the foundation or fixed with screws. Then push the rail nut into the rail and turn it 90 degrees. Insert the lower half of the tube into the nut, put the tube to be fixed, and then put it. The upper half of the tube body and cover are fixed with screws.

1, pipe clamp application range

The light series pipe clamp is applied to the general mechanical pressure pipe of 6 series series, the outer diameter of the pipe is 6-57mm.

Double series pipe clamps are applied to mechanical pressure pipes of 5 series series, the outer diameter of the pipe is 6-42mm.

Heavy duty pipe clamps are used in 8 series of high mechanical pressure pipes with an outer diameter of 8-273mm.

2, pipe clamp material characteristics: density, bending strength, impact toughness, compressive strength, elastic modulus, tensile strength, temperature resistance, color

3. Pipe clamp installation procedure: Before assembling on the welding plate, in order to better determine the direction of the clamp, it is recommended to mark the fixed position first, then weld it on the weld, insert the lower part of the pipe clamp, and put it on. Pipes to be fixed. Place the other half of the pipe body and cover plate and tighten with screws. Do not directly weld the bottom plate of the pipe clamp.

On the grounding rail, the rail can be welded to the foundation or fixed with screws. Then push the rail nut into the rail and turn 90 degrees. Insert the lower half of the tube into the nut, put the tube to be fixed, and then put it. Upper and lower tube tube body and cover plate are fixed by screws. Stack up the assembly, the guide rail can be welded on the foundation, or fixed with screws. First install the upper and lower half of the tube body, put the tube to be fixed and put it on the upper part. The upper half of the tube is clamped and fixed by screws. It is prevented from rotating by the anti-loose cover. Then the second tube clamp is installed. The method is the same as above. The assembly of the elbow should be directly at the front of the elbow and when assembling the elbow. The rear part is fixed with a pipe clamp. It is recommended that such a support point should be a fixed position.


Url:http://en.jsobgj.com/news/442.html

Tag:Heavypipeclamp

Browse:

Share 一键分享